This command doesn't work properly in 6.1(4a), 6.2(12) The 'set metric-type internal' route-map configuration command causes BGP to advertise a MED that corresponds to the IGP metric associated with the next hop of the route Behavior is changed in 6.2(6) and later to report these as a log message rather than disabling the port. ![]() The interrupt manifests when a MAC table look up result FIFO is deemed to be full and might cause packet drops. This is considered a non-fatal interrupt. ![]() Reason:Internal Error)ĭefault VDC accounting log reports a 'L2LU IG_SA result merge fifo full' interrupt Reason:Internal Error)Ģ013 Dec 3 09:20:21.643 7K-VDC2 %ETHPORT-3-IF_DOWN_ERROR_DISABLED: Interface Ethernet3/9 is down (Error disabled. Reason:Internal Error)Ģ013 Dec 3 09:20:21.630 7K-VDC2 %ETHPORT-3-IF_DOWN_ERROR_DISABLED: Interface Ethernet3/12 is down (Error disabled. Reason:Internal Error)Ģ013 Dec 3 09:20:21.623 7K-VDC2 %ETHPORT-3-IF_DOWN_ERROR_DISABLED: Interface Ethernet3/10 is down (Error disabled. ![]() ![]() The port group VDC reports the following:Ģ013 Dec 3 09:20:21.611 7K-VDC2 %ETHPORT-3-IF_DOWN_ERROR_DISABLED: Interface Ethernet3/11 is down (Error disabled. %MODULE-2-MOD_SOMEPORTS_FAILED: Module x (Serial number: xxxxxxxx) reported failure on ports Ethernet x/y-z (Ethernet) due to error in device DEV_CLP_FWD (device error 0xca802600) Port set goes into error disabled state with the following error seen in the default VDC:
0 Comments
Leave a Reply. |